Magnetek Enrange CAN-6 Manuale delle Istruzioni Scaricare il pdf (Pagina 17)

Flex 8EX System Instruction Manual

December 2013

Page 17 of 44

71423 56 8

CHANNEL

71 423 56 8

4. FUNCTION SETTINGS

4.1 TRANSMITTER HANDSET

4.1.1 System Channel Settings

(Fig. 07)

Set the transmitter channel by adjusting the channel dip-switch located on the backside of the

transmitter encoder board (refer to Fig. 07 above). Only the first six (6) positions are used for

channel programming (refer to Fig. 08 below). The system channels table located on page 34

illustrates which dip-switch setting corresponds to which channel. Once the transmitter channel

is altered, make sure to change the receiver channel as well. The channel on both the

transmitter and receiver must be identical in order for the system to work. To change the

receiver channel please refer to page 25.

Example: Top slot → “1”

Bottom slot → “0”

(Fig. 08)

The above dip-switch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system channels

table on page 34.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Nessun commento

Magnetek Enrange CAN-6 Manuale delle Istruzioni Pagina 17